![]() I tried disabling time machine, running disk recovery, re-installing Sierra through recovery mode (failed / file unavailable), re-installing High Sierra via recovery mode (installer failed), installing Sierra via a USB drive (hold down option, select USB drive with image on it), and probably something else I'm forgetting to mention. Open Diskutil and reformat the drive to APFS ****Note that you will lose any data stored on the drive**** Open Terminal and force unmount the driveģ. Boot into internet recovery mode Option-Command-RĢ. Sep 27 15:32:48 Hostname OSInstaller: Clearing automation and attempting to rebless. Sep 27 15:32:48 Hostname OSInstaller: Disk repair retry failed too many times. Sep 27 15:32:48 Hostname OSInstaller: Restoring the original state found as mounted. Sep 27 15:32:48 Hostname OSInstaller: Volume could not be unmounted. Sep 27 15:32:48 Hostname diskmanagementd: diskmanagement: : mount failed: err=-69888 un0mt1=0 timeout=0 dissenter=1 dissenterpid=0 dissenterstatus=49168=0xc010 Sep 27 15:32:48 Hostname OSInstaller: Repairing file system. Sep 27 15:32:48 Hostname OSInstaller: Storage system check exit code is 0. ![]() Sep 27 15:32:48 Hostname diskmanagementd: diskmanagement: rawLaunch_block_invoke: waitpid(2) pid=586 ret/errno=586/35 status=0x00000000 exit=0 I had no issues upgrading on my older iMac, 15-inch Macbook pro with touchbar, or VMs. I've also re-downloaded the installer several times. I've tried disk utility repairs both in Sierra, while in the High Sierra installer, and by booting into recovery mode. Other OS will operate differently.I have the exact same issue with a late 2016 27-inch iMac with 1TB SSD. This is only a potential solution for GP connection issues on MacOS. Click "Allow" and that should give the necessary permissions for Global Protect. The approval request should show 'Palo Alto Networks' as the developer. ![]() Until approval, future load attempts will cause the approval UI to reappear but will not trigger another alert. This approval will only be present for 30 minutes after the alert. This directs the user to approve the KEXT in System Preferences > Security & Privacy: When a request is made to load a KEXT that has not been approved, the load request is denied and macOS presents the alert below: ![]() To resolve this, the KEXT needs to be approved. This in turn prevents the Agent from connecting to the service. The KEXT associated with Global Protect has not been approved and so cannot be run. NOTE: Approval is automatically granted to third-party KEXTs that were already installed before transitioning to macOS High Sierra. When a request is made to load a KEXT that has not been approved, the load request is denied. MacOS High Sierra 10.13 introduced a new feature that requires user approval before loading newly-installed third-party kernel extensions or KEXTs, for short. This indicates that the Global Protect Agent cannot reach the Global Protect Service running on the client. After looking into the PanGPA.log and finding the following: It shows as constantly in the 'Connecting' state with no changes in status. Global Protect Agents installed on a MacOS is having repeated issues with connecting to the Global Protect Gateway.
0 Comments
Leave a Reply. |